Notch front X-brace
- Use sliding bevel to set angles of cuts
- Use scribe to measure 7.5mm from top and bottom of ‘A’ and ‘B’ braces
- Notch for smaller braces into bottom of X-braces
- Mark either side & cut with dovetail saw at 45 degrees then chisel out with 6mm chisel
- Glue join of x-brace
- Glue x-brace to front hold down with go-bars
- Use wood slivers to get excess glue out of smaller brace cut-outs
Back
- With block plane chamfer off braces to a slope
- Sand with 150 till tops are round
- Clean off excess glue on back by sanding
