Moulding Sides
- Removed 2nd Side from bender (was a bit charred due to being heated too long)
- Same process as 1st side to put into mould:
- Remove 1st side
- Cut roughly to size with some overlap
- Set centre line and mark with square
- Cut using block and Tenon/dovetail saw
- Place both sides into jig and tighten up block
- Had to block plane edges to fit flush
Front braces
- Cut thin flat braces for front from left over top and bottom materials (not enough for bridge brace so had to modify the shape to suit available materials)
- Glued front braces, bridge and sound hole braces and placed into go-bar jig to dry
