Took masking tape off top and bottom holding bindings in place
Gaps around bindings needed to be filled:
• Flush binding and b/w/b to sound board and back with a small block plane
• Sand spare bit of side to make pile of dust
• Mix dust with a small amount of titebond to create a past of glue and plaster into gaps!
Tuning peg holes
• Attached tuning peg template to head and clamp to bench with piece of scrap wood underneath
• Drill through peg holes with 9.5mm drill
Shaving the neck
• Attach neck jig to neck with 2 screws
• Attach bench vise piece to neck jig
• Using rounded spoke shave, plane off excess from neck block (cut majority off first with a tenon saw)
• Start on one side and shave straight chamfers .…